MultiTrode MTIC Overview

View MTIC Datasheets >>

Indicator Controller - The MTIC provides continuous level indication and control of up to ten devices. Provides 4-20mA and 0-10V output.

The simple installation and operation make this unit one of the easiest retrofit level control devices in the MultiTrode range when upgrading from ball floats. Combining the MTIC with a 10 sensor probe provides the ultimate in low-cost reliability.

• Controls up to 10 devices.
• Ten-segment level indication.
• 10 programmable N/O or N/C outputs.
• Visual indication of set points.
• Four sensitivities.
• Four activation delays.
• 4-20mA and 0-10V DC outputs.
• Panel mounted.
• Power On indication.
• Ideal retrofit for troublesome ball floats.
• Perfect for I.S. application when used with MTISB.

The MTIC is used where level indication or control of multiple pumps and/or alarms is required. The unit's simple operation and mounting allow it to be easily installed. Key MTIC features are: ten separate relay outputs (one per LED) which can be set as N/O or N/C via the DIP switches located on the rear, and the inclusion of 4 - 20mA and 0 - 10V analog outputs.

Local indication at up to four remote sites when utilising the MTRIC can be achieved by adding additional MTRIC units.

The 4 - 20mA and 0 - I0V analog outputs can operate chart recorders, variable speed drives, telemetry or other control devices. The MTIC can be connected to a MultiTrode MTRIC, MTIPC, MT2PC or MT3PC via its 4-20mA output providing full multiple pump control.

Typical applications are water reservoirs with remote pump stations or water tanks in high-rise buildings, with basement pumps.